For a complete understanding of oil types, viscosity, oil filter, part numbers and oil changing procedures for your 2007 Harley Davidson HD FXD Dyna Super Glide, FXDB Dyna Street Bob, FXDL Dyna Low Rider, FXDC Dyna Super Glide Custom, FXDWG Dyna Wide Glide & FXDSE Screamin' Eagle Dyna Motorcycle Chopper than download the full factory service repair manual. Why Pay a mechanic when you can do it for free, a service manual no do-it-yourself (DIY) mechanic should be with out. Stop the guess work and get your copy now.
ENGINE OIL AND FILTER
CHECKING AND ADDING OIL
Type of Oil
Refer to Table 1-3. Use the proper grade of oil for the lowest
temperature expected before the next oil change. See 1.2
FUEL AND OIL for specific information regarding winter
needs.
Checking With Warm Engine
Ride motorcycle until engine is warmed up to operating
temperature, then do the following.
1. Idle motorcycle on jiffy stand for 1-2 minutes.
2. Shut motorcycle off and with motorcycle leaning on jiffy
stand on level ground, unscrew and remove engine oil
filler cap with attached dipstick. Wipe dipstick clean.
3. Reinstall filler cap. Turn filler cap clockwise until it stops.
4. See Figure 1-2. Again, unscrew and remove filler cap
and check oil level on dipstick. If oil level in pan is below
lower mark on dipstick, add enough Harley-Davidson oil
to bring level up between lower mark (1) and cold check
level (2) on dipstick.
Recommended Oil Grades
CHANGING OIL AND FILTER
NOTES
●
If the motorcycle is ridden hard, under dusty conditions,
or in cold weather, the oil and filter should be changed
more often.
●
All Dyna models are shipped from the factory with SAE viscosity
Harley-Davidson Motor Oil.
●
All Dyna models come equipped from the factory with a
premium 5 micron synthetic media oil filter, Part No. (See Service Manual)
(Chrome) or (see service manual) (Black). These are the
only recommended replacement filters.
1. Ride motorcycle until engine is warmed up to normal
operating temperature.
2. See Figure 1-1. Unscrew and remove engine oil filler cap
with attached dipstick.
3. See Figure 1-3. Remove the engine oil drain plug with Oring
(1). Allow oil to drain into a suitable container
4. See Figure 1-4. Remove the oil filter using the OIL FILTER
new
oil filter with
engine oil and install
new
filter. Hand tighten oil filter 1/2
to 3/4 turn after gasket contacts filter mounting surface.
Do NOT use oil filter wrench for oil filter installation
Recommended Oil Grades
WRENCH. Clean the oil filter mount flange of any
old gasket material.
5. See Figure 1-5. Lube the gasket on
