2001 Harley Davidson Touring H-D Service Manual & 2001 H-D Electrical Diagnostics Manual for Harley Models: FLHTCUI Ultra Classic Electra Glide (2001), FLHTC/I Electra Glide Classic (2001), FLHT Electra Glide Standard (2001), FLTR/I Road Glide (2001), FLHRCI Road King Classic (2001), FLHR/I Road King (2001) and also contains the 2001 H-D FLT Police Model Service Manual Supplement and 2001 H-D FLTRSEI2 Service Manual Supplement. FLHTCUI, FLHTC, FLT, FLHTCI, FLHT, FLTR, FLTRI, FLHRCI, FLHR, FLHRI.
ENGINE SENSORS 8.4
MANIFOLD ABSOLUTE
PRESSURE SENSOR
Removal
1. Partially remove fuel tank. See Section 4.7 FUEL TANK
(CARBURETED), PARTIAL REMOVAL, FLHT/C, FLTR,
or FLHR.
2. Pull external latch outward and use rocking motion to
remove electrical connector.
3. Remove T20 TORX screw to release retaining clip from
intake manifold. See Figure 8-3.
4. Carefully pull pressure port (enveloped in rubber seal)
from hole in intake manifold.
5. If reusing sensor, inspect condition of rubber seal.
Replace the seal if it is cut, torn or shows signs of deterioration.
Installation
1. Install rubber seal on pressure port, if removed.
2. With port side down, slide end of retaining clip in slot at
side of sensor. Aligning hole in retaining clip with
threaded hole in intake manifold, carefully press pressure
port into bore,
3. Install T20 TORX screw and tighten to 25-35
in-lbs
(2.8-
4.0 Nm). See Figure 8-3.
4. Align latch on socket housing with locking tab on pin
housing and push connector halves together until latch
clicks.
5. Install fuel tank. See Section 4.7 FUEL TANK (CARBURETED),
INSTALLATION (AFTER PARTIAL
REMOVAL), FLHT/C, FLTR, or FLHR.
CRANKSHAFT POSITION SENSOR
